View Single Post
Old 05-23-2011, 1:46 AM
Ryan in SD Ryan in SD is offline
Senior Member
Join Date: Apr 2009
Posts: 1,964
iTrader: 58 / 100%

Originally Posted by straykiller View Post
hahaha jk.
i agree though, nowhere did it say that the magazine would bind with the rails, thats the way they were shown to be cut by a few different places so thats the way i did it. and i did experience the problems it took quite some time with a dremel to get the mag to fit right. it may get worse again once riveted but it wont take long to fix it again since i removed allot of material the first time.
Im going to send the list of fixes needed to their instructions. My 2nd PSL blank came last week, been taking lots of measurements of the fire control group and other areas.

I hope you didnt use their fcg hole locations.

I'm setting my trigger hole back from the hammer an extra .108" and the safety an extra X" from whats on their sheet.


Last edited by Ryan in SD; 05-24-2011 at 12:56 AM..
Reply With Quote