View Single Post
Old 12-18-2010, 1:58 PM
jazzmatazz jazzmatazz is offline
Junior Member
Join Date: May 2010
Location: SF Bay Area
Posts: 96
iTrader: 5 / 100%

Originally Posted by tenpercentfirearms View Post
I am now retailing these too and decided to try some for myself.

First, the C Products SS mags are a mother to drill through. I had to go buy some titanium bits after ruining the ones I had around.

Second, the C Products followers are going to stop you from getting all of the rounds into the magazine. I had an easy fix. I just used my bench grinder and cut a big notch in the middle of the front leg of the follower. It doesn't affect the magazine function at all and the mag works just fine.

Then I figured out that I really didn't need to drill through my magazines at all. Just install the Kit A through the magazine floorplate hole in the bottom!

How do you remove the metal plate on the bottom of the mag after doing that? Do you just pry up on the tab?

Last edited by jazzmatazz; 12-18-2010 at 2:31 PM..
Reply With Quote