View Single Post
Old 06-16-2010, 12:25 PM
mstlaurent's Avatar
mstlaurent mstlaurent is offline
Senior Member
Join Date: Mar 2007
Location: Prescott Valley, AZ
Posts: 1,374
iTrader: 4 / 100%

Originally Posted by joelogic View Post
I might have to switch to a lubing die because I am getting tried on cleaning the casefeeder and the feeder tube.
Any lessons learned?
Just buy a die and some lube?
Run a reservoir like Randall?
This is one thing I really like about the Hornady bushing system. Pulling the lube die out and refilling it takes like 30 seconds. 60 degree twist, pull the die out, lift the sleeve, squeeze the lube in, sleeve down, drop the die in, another 60 degree twist, done. When I first bought the lube die I was trying to figure out a way to put a reservoir on it like Randall did, but after I used it for a couple hundred rounds I decided that would be more trouble than it was worth.

That said, the efforts I did put into creating a reservoir centered around trying to modify a saddle valve to fit on the die body. ( You can find them in the tubing and fitting section at Lowes or Home Depot. You might start there.
I've never seen an American flag burned at a gun show.
Reply With Quote