View Single Post
Old 06-15-2010, 9:51 AM
JC Smith's Avatar
JC Smith JC Smith is offline
CGN/CGSSA Contributor
CGN Contributor
Join Date: May 2006
Location: SF East Bay
Posts: 370
iTrader: 36 / 100%

Originally Posted by joelogic View Post
I might have to switch to a lubing die because I am getting tried on cleaning the casefeeder and the feeder tube.
Any lessons learned?
Just buy a die and some lube?
Run a reservoir like Randall?
Just a suggestion. You might disassemble the lube die and check to be sure it's clean inside before you start processing the brass. I still haven't figured out where the contamination came from that scratched the inside of my size/trim die but the lube die is a possibility.
NRA Patron & CRPA Life Member

“We sleep safely in our beds because rough men stand ready in the night to visit violence on those who would do us harm.”
Reply With Quote