View Single Post
  #14  
Old 02-20-2010, 5:24 PM
VaderSpade's Avatar
VaderSpade VaderSpade is offline
Vendor/Retailer
CGN Contributor
 
Join Date: Mar 2009
Location: In the hills above Redding, CA
Posts: 3,629
iTrader: 60 / 100%
Default


Tape the surrounding area to avoid sparks and etching areas you don’t want etched.


I mixed white vinegar with a little salt, dipped a Q-tip into this solution and attached it to the negative side of the charger, then clamped the positive side to the lower.
It takes awhile, and starts slowly, but after you break through the surface the pace picks up.



__________________

Check out my engraving gallery on my website, Thanks
http://vadertactical.com/engraving-gallery

Last edited by VaderSpade; 03-01-2010 at 8:30 PM..
Reply With Quote