View Single Post
  #10  
Old 02-20-2010, 5:22 PM
VaderSpade's Avatar
VaderSpade VaderSpade is offline
Vendor/Retailer
CGN Contributor
 
Join Date: Mar 2009
Location: In the hills above Redding, CA
Posts: 3,553
iTrader: 60 / 100%
Default


I can’t express how easy this plate makes cutting the trigger hole. Before it was “Change tools from milling to drilling, take three measurements, drill three holes, change back to milling and hope you’re not too far off. Then file the little bit you WILL be off.”
With this Tactical Machining jig it take just a few moments.

Flip the jig and drill two 5/32nds holes.
__________________

Check out my engraving gallery on my website, Thanks
http://vadertactical.com/engraving-gallery

Last edited by VaderSpade; 02-21-2010 at 7:16 AM..
Reply With Quote