View Single Post
  #9  
Old 02-20-2010, 5:21 PM
VaderSpade's Avatar
VaderSpade VaderSpade is offline
Vendor/Retailer
CGN Contributor
 
Join Date: Mar 2009
Location: In the hills above Redding, CA
Posts: 3,571
iTrader: 60 / 100%
Default


Make sure the trigger slides in before you change setups.

Now put the top of the jig back on with the trigger slot plate.
You may have noticed I skipped the second plate. That plate is for the full depth part of the pocket. If you’re going to use the edge of the plate as a guide it’s a good idea to use it. For me it’s just as easy to measure it in as I clean up with the long end mill.
__________________

Check out my engraving gallery on my website, Thanks
http://vadertactical.com/engraving-gallery
Reply With Quote