View Single Post
  #2  
Old 02-20-2010, 5:17 PM
VaderSpade's Avatar
VaderSpade VaderSpade is offline
Vendor/Retailer
CGN Contributor
 
Join Date: Mar 2009
Location: In the hills above Redding, CA
Posts: 3,404
iTrader: 60 / 100%
Default


I try to get as close as possible to the edge of the plate, for the outline, but I like to leave a few thousandths for the cleanup stage.

Make sure your cutting edges are below the plate, or you will be ordering a new one.


Watch your clearance. I can’t reach the back with this setup, but we’ll clean that up later.

After you have a good outline remove the top plate, measure twice, and cut carefully.
__________________

Check out my engraving gallery on my website, Thanks
http://vadertactical.com/engraving-gallery

Last edited by VaderSpade; 12-26-2015 at 8:07 AM..
Reply With Quote