View Single Post
  #51  
Old 02-03-2010, 5:58 AM
Thordo's Avatar
Thordo Thordo is offline
Vendor/Retailer
CGN Contributor - Lifetime
 
Join Date: Jan 2010
Location: South San Francisco
Posts: 3,358
iTrader: 25 / 100%
Default

Quote:
Originally Posted by nimoZ View Post
Yes, I think it could be perfect.
That would make the button and the set screw to be just shorter than the guiding tab on the inside.
- The front sidewall + guide of my PMAG is just less than 3/16", add your button's 11/32" and you get 17/32", which gives slightly more material than 1/2"

Edit: Don't know about the new stubbies based on a later model pmag, but I would expect the wall and guide to be very similar.
Thanks for your input. I'll change The KIT B to 1/2" set screws on our next run.

Thordo
Reply With Quote