View Single Post
  #20  
Old 04-04-2013, 9:52 PM
Excaliburr Excaliburr is offline
Senior Member
 
Join Date: Oct 2011
Location: Chico
Posts: 933
iTrader: 11 / 100%
Default

With that said, I would "slug" the barrel and check the dimension of the slug. Like you said, you weighed them, so unless powder is wet or old or how about this one, flash hole full of crud (not sure if that would only set off a small part of the charge). I have a friend who forgot to clean out the flash holes once after tumbling in media. I have as of yet not done that one. Instead of slugging your barrel you could try using the caliper to measure the best you can the diameter of the inside of the barrel between the lands. If memory serves me right, mine measure like .355. I did have one in the past that measured .353 and that is the one I loaded the 9mm bullets in the cartridges. Still, slugging the barrel is best. Just trying to help.
Reply With Quote