View Single Post
  #33  
Old 02-05-2013, 11:31 PM
mud99 mud99 is offline
Make Calguns Great Again
CGN Contributor
 
Join Date: Oct 2011
Location: Bay Area
Posts: 1,077
iTrader: 11 / 100%
Default

Quote:
Originally Posted by vmwerks View Post
You would recommend this to a person who's a beginner? I've run a Bridgeport but on nothing really complicated. I would think the tooling would be a large cost too...
I can't recommend it yet, as I haven't received it yet.

Tooling is a huge cost, I probably have 3k in tooling from my last mill. Biggest mistake I made was buying sets of end mills and collets. You really only need a few collets in specific sizes, and a couple of end mills of good quality.

I don't know exactly what you mean by "beginner" - if you are an absolute beginner to metalworking I would recommend you buy a dremel, jigsaw, angle grinder, welder, bandsaw, lathe and then a mill in that order.
Reply With Quote