View Single Post
  #26  
Old 01-08-2013, 7:12 AM
JackRydden224's Avatar
JackRydden224 JackRydden224 is offline
Single stack pistol guy
CGN Contributor
 
Join Date: Aug 2011
Location: Irvine
Posts: 6,592
iTrader: 73 / 100%
Default

Quote:
Originally Posted by stilly View Post
The only thing that I can think of is that maybe the ogive or shape of the noce allowed it to sit at a different position in the seating die and as a result did not get pushed down as far.

But that is a technical reason and I do not know how I manged to say that this late at night...

heh... Switched from round nose to truncated cone perhaps? When I get a progressinve I plan to prolly teast/measure my first 10 rounds when I change powders or bullets as I figure that that should be a good thing to do to minimize jacked up loads.

I also agree that pulling that many bullets takes the fun out of reloading. Too bad they were not fmj...
I did switch from a round nose to a cone shaped bullet!

Quote:
Originally Posted by drdarrin@sbcglobal.net View Post
Just a thought... I'm sure these are well marked so that its obvious to everyone these are defective and should not be fired.
I did separate them. It was fairly easy because one is plated round nose and the other is cone shaped lead...

I'm gonna take some pictures and do some measuring when I get home today.
__________________
w210838 is the barrel guy don't forget.

Quote:
Originally Posted by HopetonBrown View Post
The average Calgunner is afraid to scratch his gun; so I don't see the point to these torture tests.
Reply With Quote