View Single Post
Old 12-28-2012, 11:39 AM
ASD1's Avatar
ASD1 ASD1 is offline
CGN Contributor - Lifetime
Join Date: Apr 2012
Location: Burlingame
Posts: 1,394
iTrader: 110 / 100%

Originally Posted by 427TriPowered View Post
greetings asd1...

i dont have any mags here... so if i whittled down a 2 x 4 and slid it into the mag well... wrote 10rd mag on it... run a sheet metal screw all the way through each side of the lower and the 2 x 4 i should be good...

technically the 2 x 4 would be a 10 round mag blocked to 0 rounds and i would need a cordless drill to get it out...

i think i have an old 2 x 4 and 3" sheet metal screw in the garage...
that would work also. it would now be a "single" shot rifle.

but use smaller screws! say 1" you don't want it to hit the other side of the magwell an mess it up. if you put 1 in from each side it is not going to fall out.
an you do not need to write anything on it.
Coyote Point Armory
341 Beach RD
Burlingame CA 94010
650315two two10

M-F 9:30-6:30
Sat-Sun 9:30-4:00

Reply With Quote