Calguns.net

Calguns.net (http://www.calguns.net/calgunforum/index.php)
-   Gunsmithing & How To (http://www.calguns.net/calgunforum/forumdisplay.php?f=114)
-   -   virgin barrel (http://www.calguns.net/calgunforum/showthread.php?t=644526)

esqui2809 11-15-2012 11:18 AM

virgin barrel
 
After finishing my build, while cleaning my barrel I noticed a small piece of metal shaving left over from drilling the gas port hole. Will this affect the first round out of the barrel? Tried time knock it off w the rod but didn't want time damage the rifling next I will try a brush any suggestions?

phrogg111 11-15-2012 11:51 AM

If you have a brass or carbon fiber rod, then a rod is a good option. Definitely use a brush.

I highly doubt it would destroy your barrel - but better safe than sorry.

savagemann 11-15-2012 12:31 PM

I usually knock em off with the tip of an aluminum cleaning rod....although I have been told to just shoot them out.

Sent from my SCH-I510 using Tapatalk 2

nicoroshi 11-15-2012 3:17 PM

I run a bore snake back and forth through the barrel after I drill a gas port hole.
The brush on it will normally take anything that might be an issue off.
If it's really small, and the above doesn't get it I shoot it out.

Dan FS71 11-15-2012 3:26 PM

You can pull a bullet and push it down the bore and it should remove the burr. Likely the 1st shot will take it out too but this is alittle less agressive

esqui2809 11-15-2012 5:45 PM

Thanks for the feedback. I tried the rod and the brush, still there ill try a bore snake then all three again if still no dice just have to send one down range. Thanks again

esqui2809 11-18-2012 7:39 PM

Went shooting today gun ran like a champ ended up just putting one down range. No issues


All times are GMT -8. The time now is 9:04 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2016, vBulletin Solutions, Inc.