Calguns.net

Calguns.net (http://www.calguns.net/calgunforum/index.php)
-   Atlantic Firearms (http://www.calguns.net/calgunforum/forumdisplay.php?f=177)
-   -   PTR 91 Bullet Button (http://www.calguns.net/calgunforum/showthread.php?t=640239)

waddlingweezol 11-05-2012 1:32 PM

PTR 91 Bullet Button
 
What bullet buttons are you guys using on the PTR 91's? are they anything like the solar tactical AK bullet buttons that don't require any permanent mods to the gun? Thanks

Atlantic Firearms 11-05-2012 4:11 PM

We use the Raddlocks and they are reversiable if you move out of CA

Son of BAR7 11-06-2012 7:59 AM

And very easy to install

waddlingweezol 11-06-2012 11:57 AM

Ok, are they riveted on? or held by screws?
Thanks

jamesob 11-06-2012 12:00 PM

Quote:

Originally Posted by waddlingweezol (Post 9666427)
Ok, are they riveted on? or held by screws?
Thanks

hk type rifles are held in place between the lower and upper assemblys. if you remove the trigger pack the bullet button falls off.

TROJAN 11-06-2012 12:12 PM

Assault Planet HK 91 bullet button is a more permanent(easily removed with no alteration to rifle) option but its a little more involved installation. There's a great tutorial here:
http://www.calguns.net/calgunforum/s...d.php?t=561449

Atlantic Firearms 11-06-2012 2:15 PM

We have installed over 200 of the HK style Raddlock mag locks and had great results

Son of BAR7 11-06-2012 4:30 PM

Quote:

Originally Posted by waddlingweezol (Post 9666427)
Ok, are they riveted on? or held by screws?
Thanks

The one from Atlantic (Raddlock, I hear) has a slightly smaller mag release button and a plastic shroud that is held in place by the trigger pack.

to install, disassemble rifle (2 pins) remove the pin that attaches the factory push button to the mag catch, replace with Raddlock button, pin button to mag catch, place shroud over button (may need to trim to fit, it's plastic and easy), re-assemble rifle, go shooting.

skibuff 11-06-2012 4:56 PM

I have a PTR91 from Atlantic with the Raddlock it works fine you just have to be careful when you break the gun down because the button shroud will fall off. I have a Bullet Button on my MKE94 it was a pain to install but is locked in with a clip so won't fall off.

waddlingweezol 11-06-2012 6:52 PM

Thanks, the reason I ask is because I travel out of state often. So when I go to AZ I like to just take off the bullet buttons, and I was wondering if it was as easy to do as it is on AK's and AR's

skibuff 11-06-2012 8:47 PM

Oh if you want it to be easy to pull off and on get the Radlock for sure. The Bullet button is held on by a C clip and is a pain to get on and off but is much more solid. The Radlock on my PTR comes off a little too easy. In fact you have to be careful when breaking it down or you will loose the shroud.

waddlingweezol 11-08-2012 7:43 PM

Sounds good, thanks


All times are GMT -8. The time now is 12:54 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2016, vBulletin Solutions, Inc.