.308 FULTON LOWER

[PIRATE14]

We have another batch of Fulton Armory Titan stripped 308 lower rcvrs.....

ORDER HERE (http://www.coldwarshooters.net/index.php?main_page=product_info&cPath=9&products_id=325)

Compatable w/ DPMS uppers and all DPMS LR-308 parts.....

We have uppers...LPK.. and mags....or get a built rifle to your specs......NM trigger....Magpul PRS....etc....:chris:

This latest batch of Fultons are improved.....there was always finish difference bwtn the Fulton and the DPMS lwrs......no more
No more machining marks...
The Roll marks are vastly improved....
No more left over finish/flashing on the safety detent hole or rear ext threads....
The last 5 I've assembled have gone together effortlessly....

CHK themout at the GLENDALE Show this wk end....

[AKman]

Uppers. Need more uppers...
POF 308 uppers anytime soon?

[BossHogg]

Uppers. Need more uppers...
POF 308 uppers anytime soon?
Yeah right

Hector ..... whats up with the sleeves for the takedown pin for the POF lower/DPMS upper config? I have the one for the pivot .... but I dont like the loosness of the rear. Thinking about just drilling the POF lower .030 bigger and using DPMS pins. Any thoughts?

[PIRATE14]

Yeah right

Hector ..... whats up with the sleeves for the takedown pin for the POF lower/DPMS upper config? I have the one for the pivot .... but I dont like the loosness of the rear. Thinking about just drilling the POF lower .030 bigger and using DPMS pins. Any thoughts?

Normally....this is where a nice accuwedge will work nicely....just trim the bttom so you get a nice snug fit.......

You could drill them out....I know of at least one guy that did that....

[BossHogg]

Thanks,

I bought 2 sleeves from your site .... so I am going to attempt to cut the other one shorter to fit the rear take down hole before I start drilling out my POF lower because eventually I want to put a POF P-308-14 14.5 inch upper (Its not SBR because they perm attached brake) on it and Use my DPMS LR 24" upper on a fulton lower.

[MT1]

I have actually just been researching building one of these rifle's. Would need the lower, parts kit, stock and possibly an upper from you.

Do you have the Fulton complete upper's available too?

I would want the 18.5" Titan Carbine Upper / Benny Cooley Brake / Target Grey Finish

Can a Larue Tactical hand guard be put on those uppers?


Thanks

[PIRATE14]

I have actually just been researching building one of these rifle's. Would need the lower, parts kit, stock and possibly an upper from you.

Do you have the Fulton complete upper's available too?

I would want the 18.5" Titan Carbine Upper / Benny Cooley Brake / Target Grey Finish

Can a Larue Tactical hand guard be put on those uppers?


Thanks

We have the fulton uppers.....
You need a 308 LPK and 308 Buttstock kit.....

Normally if they have it for DPMS....than that rail will work with the uppers

[MT1]

Ok - Thank you, I am still trying to decide between the .308 and a 6.5 Grendel build.