PDA

View Full Version : 22-6mm loads


ic-doc
08-11-2012, 5:17 PM
Newbe--are there any folks that have load data for 22-6mm? I have Varget, IMR-4064 and IMR-3031. I have Hornady A-Max 52gr and HPBT bullets as well at 55gr bullets. Thus far, 43gr of Varget work well the first time but primer pockets are expanded such that Federal 210 primers will not seat and stay put. 55gr of IMR-4064 has the same issue.

So, are there any other loads that seem to work for the 22-6mm?

BlackTydeTactical
08-11-2012, 7:42 PM
Welcome aboard!

Meety Peety
08-11-2012, 7:48 PM
Welcome to Calguns! You'd have much better luck finding an answer to your question if you repost it to the "Ammo and Reloading" section of the forum found HERE (http://www.calguns.net/calgunforum/forumdisplay.php?f=89)

SoCal Bob
08-11-2012, 8:06 PM
Welcome and good luck with your knowledge quest.

bsg
08-11-2012, 8:09 PM
welcome to the forum.

Fjold
08-11-2012, 8:15 PM
You can Google 22-6mm loads and use the data from AccurateReloading.com, ReloadersNest, Shootersforum,etc.

Or you can the starting loads for the 22 Middlestead (22-243) and work your way up. Since the 6mm case is slightly larger than the 243 case it will be on the conservative side of the pressure curve.

h0use
08-11-2012, 9:26 PM
welcome

DeanW66
08-12-2012, 1:26 AM
Welcome aboard! As has been pointed out, you're better served looking into appropriate subforums when you have a questions. Most folks here don't look into the "new here" area for Qs to A.

zod
08-12-2012, 10:50 AM
Welcome aboard.

NastyNate
08-12-2012, 4:44 PM
Welcome aboard.

Wicked Pete
08-12-2012, 7:46 PM
Welcome.

Another forum might provide the answers. Good Luck.

socalpistolero
08-12-2012, 8:02 PM
welcome.

frankDmole
08-13-2012, 4:00 PM
Welcome to CalGuns.

Sonny188
08-13-2012, 5:19 PM
Welcome!

GladiatorTactical
08-13-2012, 8:01 PM
Welcome to CalGuns