PDA

View Full Version : BCM Extractor Spring Too Small?


The1stWright
04-12-2012, 7:12 PM
I'm trying to install this new spring to try and figure out my FTE problems. But for some reason it doesn't fit. The spring is also smaller than the original. What gives? Also the o-ring is way too big.

glock7
04-13-2012, 5:17 AM
a little more detail and some pics would help to analyze your problem. you'll get more folks to come on board. good luck.

The1stWright
04-13-2012, 7:36 AM
It's ok I figured it out and was able to install the spring. Thanks for responding glock.

AAShooter
04-13-2012, 9:02 AM
So what was the issue?

The1stWright
04-13-2012, 10:51 AM
had to turn the spring counter clockwise to get the spring to lock in place.

glock7
04-13-2012, 11:12 AM
Good for you. If you play with it long enough, something good is bound to happen....;)

cornice6
04-16-2012, 6:24 AM
Did you install the O-ring that came with it as well? Have you fired it since the install? Wondering if it helped your FTE issue.

coltn46920
04-16-2012, 12:31 PM
Extractor springs are a PITA to install.

Does the rule of installing counter clockwise apply to all extractor springs?