View Full Version : Use 0, 10 or 20 MOA scope mount?
03-16-2012, 9:11 PM
With an AR 308 receiver that has 0 MOA, using a scope with say 80 MOA, zeroed at 100 yrds, if trying to pump it out up to 1000 yrds, would it better to use a scope mount with 0, 10 or 20 MOA?
03-16-2012, 9:53 PM
Cant would be left or right tilt. A 20 moa base will usually do 100-1000 yards if your scope can get there.
03-16-2012, 9:55 PM
Shouldn't need any more elevation (not cant) unless your 100yd zero is above "halfway" in elevation travel. You can get to 1K from a 100yd zero with much less than 40MOA.
03-16-2012, 11:01 PM
20MOA. Better have it and not need it than need it and not have it.
03-16-2012, 11:10 PM
03-16-2012, 11:12 PM
Just as a note usually only expensive scopes have that kind of adjustment.
03-16-2012, 11:14 PM
20 MOA. 308 will need about 25-30 minutes of adjustment to get there. If you get a standard, all of that adjustment below your zero will be wasted.
Zero at 200 and use a 20MOA base.
03-16-2012, 11:57 PM
03-17-2012, 6:17 AM
Have a Leopold 3.5-10x Vari X III LR, has exactly 82.3 MOA.
Have a Larue 762 with 0 MOA receiver coming in about 4 months and picking up a Larue 556 with 20 MOA built-in in a few days, I'll get a 20 MOA scope mount for the 762 as suggested. For now, I'm just deciding if I should get a higher power scope for the 762 and maybe throw the 3.5-10 on the 556 or just keeping an Aimpoint micro on it instead and keeping it as light as possible.
vBulletin® v3.8.9, Copyright ©2000-2016, vBulletin Solutions, Inc.