PDA

View Full Version : Question in Lower build


RAMCHARGER
03-12-2007, 10:18 AM
OK I just assembled my OLL and I noted something interesting.
When testing the hammer with no upper on the lower.
I hold the trigger back and the hammer goes forward (yes I hold it with my thumb so it dont slam on to the receiver/Bolt hold open thingie).
NOW if I keep holding down the trigger and then pull back the hammer it locks in place. OK so far.
But when I release the trigger..the hammer clicks up. As in it pops up a little bit. Is this normal?

guimus
03-12-2007, 10:22 AM
yes


1234567

Prc329
03-12-2007, 10:26 AM
That is the trigger reseting. When shooting I usually hold the trigger back and let it go till i feel/hear that click. It makes for a faster reset, especially on a two stage trigger. The second stage would be the click.

pksbshp
03-12-2007, 10:30 AM
Yes, when the hammer comes back the disconnector catches the hammer, and when you release the trigger the disconnector releases the hammer and the trigger catches it.