View Full Version : WTS - Rivet Jig Arm - (Attn: AK Kit Builders)

Dan FS71
12-25-2011, 2:27 PM
(These will fit Akbuilder, Akmachinist, Plinker Jig, etc)

You may have found the consumable part is the arm. They start to look like a bananna - your rivets into bent nails.
Clean rivets are the hallmark of a professional.

Just like the originals

$35 Shipped

http://farm7.static.flickr.com/6066/6109690196_6e2992499e_z.jpg (http://www.flickr.com/photos/62800920@N03/6109690196/)

http://farm7.static.flickr.com/6164/6169878520_617e6c1057_z.jpg (http://www.flickr.com/photos/62800920@N03/6169878520/)

These Arms are made from O_1 drill rod (oil quench). Here is the hardening table if you care to try & extend the service life. --- If you have questions, don't hesitate.
http://farm3.staticflickr.com/2823/9368100440_4aedbdf809.jpg (http://www.flickr.com/photos/62800920@N03/9368100440/)

12-26-2011, 10:16 AM
Dan, I take 10 of the mill bits and 1 jig arm .

Dan FS71
12-28-2011, 10:41 AM
PM's replied to, items shipped.

Dan FS71
01-02-2012, 10:24 AM

Alittle less than 60 endmills left.

01-02-2012, 12:27 PM
Hi Dan,

I'll take 10 endmills.

pm to follow .

Dan FS71
01-07-2012, 8:55 AM
Paid & shipped

Less than 50 left.

Dan FS71
11-14-2012, 8:22 AM
Have 1 jig arm left for the akmachinist rivet jig if someone is in need.