View Full Version : Pinning FSB on Saiga conversion

11-26-2011, 9:59 AM
I removed the factory FSB and replaced it with one that would allow me to use the '74 muzzle brake. I've shot it and determined that it is on there straight. All I have left to do is pin it. The FSB came with a pinning kit from Dinzag, and one pin is longer and one pin is just a tad shorter. Also, there are two drill bits that came with the kit as well (one is bigger than the other). Can someone tell me why one is shorter than the other, and which one is supposed to go where?

Thank you.

11-26-2011, 9:02 PM
Shoot Brian an email. Not sure it matters cut the longer one to size if you need.

11-26-2011, 10:59 PM
Spec is 3mm or .118". It really doesn't matter too much just get a pin in there to keep it from moving.