PDA

View Full Version : 500 down


problemchild
10-01-2011, 7:56 PM
500 down and only 15,500 to go. :D

I hope to be the best ammo'd up shtf guy in town after a little bit of work.

I stocked up on once fired brass (16k), pulled military powder (32lbs) and pulled bullets (16k). Now I just have to assemble them all. Might take me a while. The dillon 650 sure makes short work of loading though.

http://youtu.be/lbA5uHMhEBg

EL_NinO619
10-01-2011, 9:29 PM
Do you really trust that military powder?

Seeker
10-01-2011, 9:34 PM
Nice. How much did all the bullet components cost in total?

freonr22
10-01-2011, 9:34 PM
You need a bullet feeder for this project. When you are done, I bet you can sell it for 80% of purchase cost

problemchild
10-01-2011, 10:17 PM
Do you really trust that military powder?

Ill let you judge that. But to expand on that a little it shoots better than Federal Gold Medal Match at 45 box of 20.

5@100
http://www.michaelkdickson.com/webjunk/LMT/Nightforce/NF-LMT-range%20001a.jpg

fabguy
10-02-2011, 10:14 AM
I watched your video and had a question, Am I too OCD because I check my charge around 10- 20 rounds to make sure it's consistent? I have a Hornady LnL progressive.

problemchild
10-02-2011, 1:05 PM
I watched your video and had a question, Am I too OCD because I check my charge around 10- 20 rounds to make sure it's consistent? I have a Hornady LnL progressive.

Dillon has a powder check that will alarm if high/low error occurs. I can also watch the stick move up and down and see where it lands in the groove to tell how much powder is in the case. Add to that the powder safety bar and you NEVER have a powder charge error again.

Never leave home without it.

http://youtu.be/UafkPd06_F0