PDA

View Full Version : AK Tool Mag Release Idea


arguy15
01-07-2007, 8:19 PM
The idea is to modify the magazine release tab by bending it back until there is just enough room in between it and trigger guard to fit a slot screw driver. Some minor mods would have to be done with a dermal tool to the mag release tab as well as some bending. It would be near impossible to remove the magazine with out a tool if done properly being that the AK trigger spring is tough as is. I am ordering an AK trigger guard now and with post a prototype ASAP. Just trying to get the ball rolling on this one. Any more ideas?