PDA

View Full Version : Is the MSAR STG-556 223 rifle with 20" Barrel w/Welded Compensator Ca ok?


mtenenhaus
05-17-2011, 3:41 PM
Hi, wondering if the MSAR STG-556 223 20" Barrel w/Welded Compensator is ok for California or what modifications have to be made to make it ok...and who does this kind of work? thank you

I saw this for sale out of state.

TheDeej
05-17-2011, 3:45 PM
Bullet button and 30" OAL should be GTG, I've seen them for sale in Cali shops.

mlevans66
05-17-2011, 3:47 PM
I think so. I saw a couple of those in the guns for sale thread.

Sicarius
05-17-2011, 4:01 PM
You just need a bullet button and you are good.
Kevin

PRE-EMPTIVE STRIKE
05-17-2011, 5:06 PM
With a 20" barrel then all you need is a bb, but you can get them in cali ready to go. I'm assuming youre getting it out of state because of the price, but after all them fee's, it might come out the same if you bought it in state.

I have a brand new one in od green with 6 mags, 16 inch barrel, assault rifle case, scope and rings if youre interested.

Pm me if interested.

osis32
05-17-2011, 5:09 PM
Any idea if the raddlock for the stg 556 works in the e4?

jokat989
05-17-2011, 5:22 PM
you dont need to weld a flash hider if your bbl is over 16 inches

Josh3239
05-17-2011, 5:27 PM
Of course not, they are two different models. An E4 rifle needs an E4 raddlock. It cannot be installed without a special tool, find user Radd on this forum and email him.

Any idea if the raddlock for the stg 556 works in the e4?

osis32
05-17-2011, 5:41 PM
I've looked I didn't see any e4 specific lock.I'll email him on his web site. The only e4 specific lock I've seen was by assault planet or something and my understanding is it doesn't work very well. I know about the special bit I already have the stock and have contacted msar.

monorailboy
05-20-2011, 11:03 AM
You can get our bullet button from Rifle Gear. I have the 20" and OAL was perfect...just needed the bb which I bought from them and had it shipped to the out of state seller, who installed it so it was in compliance when received at my ffl. It is a beautiful gun !!!

762.DEFENSE
05-20-2011, 12:49 PM
Put a BB on that sucker, and you're good to go! :thumbsup:

osis32
05-20-2011, 2:06 PM
Yeah I know but I'm having a hard time figuring out which one

Lagduf
05-20-2011, 2:33 PM
Has a user installable magazine lock been developed for these weapons yet or is it still a dealer install due to the "special tool?"

osis32
05-20-2011, 4:02 PM
The e4 can be user installed you just need to call msar and get their special bit. I'm going to do that once I figure out which lock to use. It's not a special install tool it's a proprietary bit to remove their stupid proprietary screw.

missiontrails
05-21-2011, 6:11 AM
Just curious... what's the selling point for these rifles? I have not had a chance to mess around with one.....

Beelzy
05-21-2011, 6:17 AM
As someone who is familiar with M/T products, I would buy something else.