PDA

View Full Version : WARNING: Possible issue with HP's and CZ75 magazines


J.D.Allen
04-21-2011, 2:15 PM
Anyone else had this issue?

Using ten round mags for a CZ 75B, with 147 grain Golden Saber HPJ's. Sometimes the rim of the bullet tip gets caught on one of the observation holes in the magazine body, holding the spring down and causing the rest of the rounds not to feed. It has happened to me quite a bit, but so far only when unloading the mag by hand. If anyone uses one of these for carry it could be catastrophic if you have to pull your weapon and none of your bullets will feed...


For some reason, even though they appear to have the same holes, I have not had this issue with the 16 round mags...

BigFatGuy
04-21-2011, 3:01 PM
Does the round always catch on the SAME observation hole? Does it only happen with one magazine? There may be a burr or dent at that spot...

J.D.Allen
04-21-2011, 3:32 PM
No. happens with both my ten rounders. I had noticed that the golden sabers are just a smidge longer than some other HP's perhaps they're just too long