PDA

View Full Version : Pinning a GEN 2 ACS stock?


Randee
04-08-2011, 9:36 AM
Hey Everyone!

Hope your Friday is treating you well!

Not sure if there are any other featureless users that have run into this but I am currently in the process of turning my SPR into a featureless SPR so I can run classes and compete legally using my 30 round mags.

Well apparently after trying to pry the tubes off I came to find out they are pinned into place, so my question is have any of you fellow calgunners run into this issue and have any of you found a solution? I really like my ACS and would prefer not to have to invest more money into a new stock just to go featureless.

Any help is appreciated.
Thank everyone!
-Randy

FeuerFrei
04-08-2011, 4:48 PM
1/8" drill bit and matching size cap screw will lock your stock in place and you can take it out if you go back to a BB/10 rounder config.
Just look at the release lever (from the side) and drill in a spot that covers the lever and stock.
It should be just plastic you're going through.
Turn the screw out and adjust the stock as needed then re-tighten it.
I have no pics.

IPSICK
04-08-2011, 5:24 PM
You guys and your silly drills.