PDA

View Full Version : anyone do the "15 Minute Practical Trigger Job for the AR-15"?


damndave
03-19-2011, 5:54 PM
Thinking about doing the 15 Minute Practical Trigger Job for the AR-15 (http://www.sargenthome.com/15_Minute_AR_Trigger_Job.htm) to hold me over until I buy another Geisselle.

Any good or bad experiences with this particular trigger job?

Vtec44
03-19-2011, 5:59 PM
I bent the trigger spring but didn't cut the hammer spring. It's a bit lighter than standard trigger after. So far so good.

RawImpact
03-19-2011, 6:52 PM
Yes, i did it and it made a world of difference. The amount of pull before the hammer release is still there, but it is def. a lot smoother and lighter.

The Good: Well obvious better trigger and you can replace the spring if you don't like it.

The Bad: Still not as good as the 100+ dollar triggers, but that's expected.

jak77
03-19-2011, 7:40 PM
Interesting...maybe Ill give this a go.

EBR Works
03-19-2011, 8:15 PM
I have done a couple of these with much improvement. Cheap and easy. :D

damndave
03-19-2011, 9:04 PM
When you guys did it, did you cut the trigger spring like it says or just bend it up?

EBR Works
03-19-2011, 9:09 PM
I cut them.

Reductio
03-19-2011, 9:38 PM
Well I just did it to one of my lowers, (Cut the hammer spring, bent the trigger spring) and it certainly at least feels smoother, now I got another excuse to hit the range. :D

damndave
03-20-2011, 2:06 AM
Just did it on mine and it definitely helps. I still need to do a little more polishing though.

railroader
03-20-2011, 7:37 AM
I did one and it came out good. The next one I did the pull was lighter but it still felt really gritty. I sent those parts to Bill Springfield and had them reworked. It's fine now. Mark