PDA

View Full Version : Trigger sticks on .22 AR


ryee30
03-06-2011, 12:16 PM
Hi

I just finished putting together my .22 AR. I used:

CMMG dedicated upper
Mega stripped lower
Enhanced LPK from Spikes

I just same back from the range and had a problem with the trigger. When fired, it sticks a little bit and does not fully reset.

I need use my finger to push the trigger back into place so that it can be fired again.

This loosened up after about 200 rounds. However there is a hesitation still when the trigger resets.

Any idea what I may need to adjust?

thanks,

shadow65
03-06-2011, 2:07 PM
First, make sure it's properly installed. Make sure the disco spring is seated.
I've seen some post on Spikes trigger sets that had some pretty rough surfaces lately. Probably just a bad batch. Not typical of Spikes. I would advise you to contact Spikes. You may have one. They have good customer service.
Dave