PDA

View Full Version : Attn OLL pinned mag AK builders


Pokey
08-02-2006, 3:58 PM
Krebs custom has an enhanced AK safety that has a notch in the top to allow the bolt to be trapped in the open position, looks like it would make loading without field stripping alot easier. I'll definately be ordering one. Heres a link
http://www.krebscustom.com/CustomParts.html#akselectorlever
You'll have to scroll down a little.

JHC
08-02-2006, 5:41 PM
Those are also nice to have if you are going to the range. As for saving time by not having to field strip it doesnt help me, every time I try to load through the ejection port I end up peeling back a fingernail,.......stupid sausage fingers of mine.:o

socalguns
08-02-2006, 11:46 PM
hmmm, sausage :D :p :)

TKo_Productions
08-02-2006, 11:52 PM
hmmm, sausage :D :p :)

http://www.vwenthusiast.com/yabbse/attachments/homer-drool.gif

leelaw
08-05-2006, 1:53 AM
For those who would like to do this on the cheap, do this:

Pull the bolt rearward. Note the space between the front of the bolt carrier (where it meets the gas piston) and the front trunnion. Stick the pointy end of a cartridge in there. Slowly ease the bolt forward until it catches.

morepoop4u
08-05-2006, 2:44 AM
For those who would like to do this on the cheap, do this:

Pull the bolt rearward. Note the space between the front of the bolt carrier (where it meets the gas piston) and the front trunnion. Stick the pointy end of a cartridge in there. Slowly ease the bolt forward until it catches.

Or spend the $50 on a dremil and cut a notch in your own selector:rolleyes:. Selectors cost $10 used + $40 to cut a 1 inch notch, I rather buy another case of wolf. Here's a DIY link for yah http://hunting.about.com/od/guns/ss/ak_safety_notch.htm