View Full Version : sig p226 trigger question

Vanilla Gorilla
12-10-2010, 12:19 PM
so I have a sig p226 dak and I like it but the trigger pull is a little long for me is there any way to shorten the pull of the trigger would a srt kit do the trick for this any help would be much appreciated

12-10-2010, 2:18 PM
The trigger travel can not be shortened and the SRT would have no effect on the DAK trigger as it only affects the reset to the SA trigger.

If you are saying that the reach to the trigger face is too long for your finger, you could try the Short Trigger or the E2 grip assembly

Vanilla Gorilla
12-12-2010, 11:14 AM
It isn't that reaching the trigger is a prolem I have large hands I just wanted to shorten the pull if it can't be done then that is cool I can get use to it

12-12-2010, 11:35 AM
Got it...no, it can't be shortened.

It might be possible to take some of the slack/takeup out with the insertion of an internal stop, but I doubt it would be cost effective...unless it was part of having other action work done