PDA

View Full Version : Anyone know any good Gunsmith in SoCal that will work on PS90?


Stubbie
10-28-2010, 5:30 PM
I planning increasing the length of the PS90 barrel to meet the minimum length requirement. I figure that will be the most beneficial method to meeting the state requirement because it at least add some extra velocity down the barrel. However from what I understand is that the flash hider/barrel shroud is pinned to the barrel from the factory.
Does anyone know a gunsmith near OC is willing to drill out and remove the factory barrel?
My plan is to install a 18" barrel (from http://www.hi-desertdog.com/index.php?_a=viewProd&productId=14 ) , and adding a fake suppressor to the end of the barrel to meet the 30" requirement, then fill in the thumb hole.
How does this sound? Thanks for reading.

Stubbie
10-28-2010, 11:51 PM
bump

SoCal Gunner
11-02-2010, 3:14 PM
I don't know a gunsmith, but I've read that increasing the barrel length (thus increasing the velocity) may require work to the bolt to compensate.

Veggie
11-02-2010, 3:24 PM
Ar15barrels.com is in OC I believe.