PDA

View Full Version : WTS: Mega Billet AR15 upper w/ 20" Krieger Match barrel


ott1
09-30-2010, 12:49 PM
Mega Billet AR15 Upper w/ 20" Krieger Match Barrel (heavy profile). The barrel came from a new KAC Match Upper. Less than 50 rounds have gone through the barrel since completion. Currently, the forward assist has been replaced with a delrin plug. I will include the forward assist assembly with the upper. The Midwest Industries SS12 FF handguard comes with 2" rail section (installed) and 4" rail section (not installed). This upper comes also comes with a charging handle and the original FailZero BCG without the NickelBoron plating. Pin it to your AR lower and you will have a ready to go tack driver able to shoot 5.56 and .223 ammo without problems.

http://imageshack.us/scaled/thumb/690/img1211gj.jpg (http://imageshack.us/photo/my-images/690/img1211gj.jpg/) http://imageshack.us/scaled/thumb/11/img1212xmw.jpg (http://imageshack.us/photo/my-images/11/img1212xmw.jpg/) http://imageshack.us/scaled/thumb/818/img1213si.jpg (http://imageshack.us/photo/my-images/818/img1213si.jpg/) http://imageshack.us/scaled/thumb/12/img1214ij.jpg (http://imageshack.us/photo/my-images/12/img1214ij.jpg/) http://imageshack.us/scaled/thumb/690/img1215zr.jpg (http://imageshack.us/photo/my-images/690/img1215zr.jpg/) http://imageshack.us/scaled/thumb/197/img1216a.jpg (http://imageshack.us/photo/my-images/197/img1216a.jpg/)

The discoloration in front of the gas block on the barrel came about from during gas block installation. A propane torch was used to heat up the gas block so the gas block will slip on the barrel (with cerakote). It was a bit tight. Installation done by Randall (AR15 barrels). I'm not sure the the discoloration can be removed by acetone or mineral spirits. I haven't tried.


Mega Billet Upper w/ M4 feedramps
* Upper receiver cerakoted matte black
Krieger 20" Match Barrel (heavy profile) - .223 Wylde chamber. 1 in 7.7" twist
* barrel cerakoted tungsten grey
Midwest Industries SS12 free floating Rifle length handguard
Vltor low profile gas block
rifle length gas tube
Magpul front and rear BUIS (black)
bipod adapter
Badget Tactical Latch charging handle

Asking $1400obo. Located in La Verne/San Dimas area. Prefer cash ftf or shipped for $25.

ott1
10-02-2010, 12:49 PM
btt

ott1
10-05-2010, 4:15 PM
btt

ott1
10-08-2010, 1:32 PM
btt

ott1
10-09-2010, 7:13 PM
btt

ott1
10-11-2010, 9:16 AM
btt

ott1
10-16-2010, 9:19 AM
btt

ott1
10-18-2010, 11:09 AM
btt

ott1
10-23-2010, 2:57 PM
btt

ott1
11-03-2010, 1:25 PM
btt

ott1
11-26-2010, 6:44 PM
btt

ott1
01-04-2011, 10:38 PM
btt

ott1
02-07-2011, 7:56 PM
btt

ott1
03-27-2011, 12:47 PM
btt

ott1
01-02-2013, 11:02 AM
Back up for sale!

thefinnatic
01-02-2013, 11:11 AM
PM Sent....