PDA

View Full Version : **GONE** Foam cutter Table project **GONE**


mig79
09-08-2010, 2:51 PM
** GONE, thanks Clear **

I was going to make this so i can cut the foam on my pelican.

The table is roughly 2'x2' about 7 inches tall. It includes the required transformer and dimmer switch (they are brand new), and i also have some springs for adding tension to the wire. All you need to finish it off is some brass rod, Ni-Chrome wire, and a power cord. It is in El Monte, CA. Its been taking up room in my garage for a while now and it needs to GO!! Free come get it!

http://i40.photobucket.com/albums/e214/mc2912/bike/IMG_20100907_120439.jpg

Here are some links to the instructions i was following.

http://www.ar15.com/forums/topic.html?b=3&f=4&t=292695

http://www.ar15armory.com/forums/Rifle-Case-Foam-Cutting-t76975.html

Needs to be gone by saturday, 9/11

Clear
09-09-2010, 10:09 AM
PM sent, just what I need