PDA

View Full Version : R700 Work needed where to go?


evollep3
09-05-2010, 9:19 PM
I want to get a Tactical Knob and also I want to get a Bell and Carson stock installed and bedded in the Stockton and Sacramento area any recommendations?

submoa1
09-06-2010, 7:20 AM
J And G Gunsmithing is a premier and certified Remington gunsmith. I got my BC A2 stock from stockys and had JG install a Badger Knob all for about 130 if I remember correctly.

Bobula
09-06-2010, 7:33 AM
I want to get a Tactical Knob and also I want to get a Bell and Carson stock installed and bedded in the Stockton and Sacramento area any recommendations?

I've seen Mike at Sierra Gun Works in Pioneer do some amazing work at very reasonable prices. Little over an hour drive for you though.
Sierra Gun Works
23885 Carson Dr, Pioneer, CA‎ - (209) 295-3219‎
www.sierragunworks.com

Bongos
09-06-2010, 11:52 AM
if you send it, Bolt knob work, RD Precision can get it back to you last than a week, you just send in your bolt.

Spdjunkie
09-06-2010, 11:56 AM
if you send it, Bolt knob work, RD Precision can get it back to you last than a week, you just send in your bolt.
+1 Agree, R&D Precision for the Over sized Tactical Knob

www.rdprecision.net

submoa1
09-08-2010, 7:05 AM
+1 Agree, R&D Precision for the Over sized Tactical Knob

www.rdprecision.net

Not my thread but thanks for the heads up on RD.