View Full Version : finally started my ar build

04-30-2010, 9:57 PM
went with a jd lower / dpms lower parts kit / bullet bullet with <the dorky red tool>that can make it eject-able out of california / got 1 10-30 magazine to start. made sure i stored the little gay red button in the garage and did not leave it in the damn gun..:excl:..:clap::clap:

did the assembly myself and it was quite easy,that stubborn front pin with detein was easy,bought a extra front pin for a spare and went in threw the left side then pushed it out from the right,was sweet.

shopping list for the gun show are:
2 more 10-30 mags + 1 regular 10 round for the p.c. ranges
stag 3h complete upper
complete 6-point stock kit w/ sling plate

any suggestions from the forum??

04-30-2010, 10:38 PM

05-01-2010, 4:46 AM
Don't forget your BUIS.

05-01-2010, 8:21 AM
I know already have a BB, but from your comments, you don't seem too excited about it.:)

Have you seen the Vamfire M.L.D. ( Magazine Locking Device)? It's a two position mag lock.





You should also look into the FreeLock upgrade for your current BB as well.


05-01-2010, 8:30 AM
Ammo, ammo, ammo! And enjoy! Keep us updated!

05-01-2010, 6:42 PM
i am happy with the bullet button just think it will look dork when i go shoot with the red piece on in havasu,was happy i took the advice of a cal-gunner and did the assembly my self to learn.it was quite easy using a printed manual and the calgun builders page.thanks cal guns.

now the wait for the stock assembly and complete upper,got 200 rounds and will pickup a brick at the show.

also does anyone recommend using the spikes .22 mod for receiver for the wife?? though i would ask and see if it is worth the 200 bucks to buy..