PDA

View Full Version : What do I need to convert a Sig P229 DAK into SA/DA?


himurax13
03-30-2010, 4:22 PM
Does anyone have a list of all of the parts I would need to swap out? It doesn't seem like it would take too much to do.

himurax13
03-30-2010, 4:54 PM
Never mind, I found the info.

Parts to convert from DA/SA to DAK

* DAK Hammer
* DAK Hammer Strut
* DAK Mainspring
* DAK Safety Lever
* DAK Sear
* DAK Sear Spring
* DAK Trigger Bar
* Note: Not all frames are DAK compatible. If in doubt, call SIG SAUER Customer Service with your serial number. (603)772-2302

Parts to convert from DAK to DA/SA

* Decocking Lever
* Decocking Lever Spring
* Decocking Lever Bearing
* Hammer
* Hammer Strut Pin (except P239 which is integral) *Note* Recently, #34280325 and #34280325N have been coming with the Hammer Strut Pin already installed
* Hammer Reset Spring
* Hammer Strut
* Mainspring
* Safety Lever
* Sear
* Sear Spring
* Trigger Bar

POLICESTATE
03-30-2010, 4:58 PM
How much is that going to set you back? I don't like DAK myself but then I don't buy DAK :43:

himurax13
03-30-2010, 6:30 PM
How much is that going to set you back? I don't like DAK myself but then I don't buy DAK :43:

Well I bought the P229 because it was # 1 of 1000 Homeland Defense. In truth, I don't know if I want to put too many rounds through it.