PDA

View Full Version : HELP! Gas block question


RERAIL1982
08-26-2009, 5:34 PM
I just finished installing my new gas block and I can't get the roll pin for the gas tube all the way through the gas block. It's about .100 of an inch off but is not fully seated. Is this going to be a problem for me when i go to shoot it or am I just worrying about nothing. Has anybody else had this problem?

alpha_romeo_XV
08-26-2009, 5:42 PM
Use a bigger hammer.
Is it so loose that it could back out while shooting? As long as it doesn't back out it should hold the GT in place. Was the new block a std A2, an A3 or some fancy low profile block?

RERAIL1982
08-26-2009, 6:07 PM
It's for a low profile GB and no it's not loose but it just bothers me that it's not seated correctly.