View Full Version : AR Optics - Aimpoint Clones

Flying Bones
07-26-2009, 12:41 PM
First up, Aimpoint M4 Clone.

It's been mounted, and fired to assure accuracy and functionality (may have a nick or two). 5 different brightness settings. Holds zero, including no changes between brightness settings. The mounting is superb. I was able to mount, remove, and mount again and zero was maintained. Very Impressive.
$85 Shipped SOLD


Next is an Aimpoint M2 Clone. Same as above, mounted and fired, it holds zero and performs very well. Red and Green dot settings. Again, it's been mounted, so it may have a nick or two but it's proven to work well.
$75 Shipped SPF


If you want the M2, I also have a 3x magnifier. It would come with a low profile mount. The mount is the rotate to side type. You push the button and rotate 90 degrees then remove the optic, leaving only the magnifier base in place.
$60 SPF


Due after "I'll take it"
Paypal +4%

pennys dad
07-26-2009, 12:52 PM
PM sent

pennys dad
07-26-2009, 1:17 PM
ok quick question: If I get the M4 clone do i need the 3x magnifier? Let me know please.

07-26-2009, 1:20 PM
I'll take clone 1!

Flying Bones
07-26-2009, 1:52 PM
ok quick question: If I get the M4 clone do i need the 3x magnifier? Let me know please.

You do not need the magnifier with either optic. The magnifier will only work with the M2 clone. The magnifier will not work with the M4 clone. The M4 clone uses a higher mount than the M2 clone.

07-26-2009, 2:55 PM
I'll take M2 or M4 clone if anything falls through, thanks.