PDA

View Full Version : FS 80% AR 15 Lower


mrhappy
07-20-2009, 12:59 PM
FS DSA forged lower that started as a 0% 7075-T6 forging, was sent out to have mag well EDM'ed, buffer tube drilled & tapped, FCG and safety holes drilled, safety hole drilled, front and rear takedown holes drilled. Top and bottom of receiver were milled and squared to spec and holes located off the mag catch location hole.
Remaining work needed is: mag catch holes/slots finished, bolt catch holes/slots finished, FCG milled out, buffer retainer hole, front and rear takedown retainer holes, trigger guard holes drilled, and front takedown slot milled.
There is some stamping of caliber and serial # on the mag well portion of the left side, and F and S stamped on the safety selector location.
Asking $95 shipped.

mrhappy
07-21-2009, 1:08 PM
BTT

freonr22
07-21-2009, 1:26 PM
it looks like the front and rear take down holes are present. do they just need final ream/finish?

mrhappy
07-21-2009, 1:50 PM
I tried a 1/4" transfer punch out of my set and it will not fit, so I'd think they need to be reamed.