PDA

View Full Version : AR with #8.5 Trigger Pull ( Yikes )


hylander
05-30-2009, 4:57 PM
Just put together a Stag Lower, RRA LPK
Trigger pull is a unreal #8.5 :eek:
How do I tame this thing down, short of installing a Jewell or other expensive Trigger set.

HkUSP45
05-30-2009, 5:03 PM
http://www.triggerwork.net/ar15s.html

Bladewurk
05-30-2009, 5:03 PM
polish with felt wheel on a dremel, do not buff thru case hardening just buff lightly, use JP Springs @ $8.00 from Brownells and reassemble with grease on sear and hammer contacts

gn3hz3ku1*
05-30-2009, 5:06 PM
change the springs? that is a bit high... you sure you got everything installed right? nothing backwards right?

BigBamBoo
05-30-2009, 5:16 PM
............

RRangel
05-30-2009, 5:30 PM
Try Bill Springfield. At $35 you can get a good 4lbs trigger if you take yours out and send it in. I had mine back in under a week. Really.

Bill Springfield (http://www.triggerwork.net/ar15s.html)

5968
05-30-2009, 5:54 PM
I would invest in one of these:

http://www.timneytriggers.com/sunshop/

I use a 3 lb. and a 4 lb. one in both my AR's. Good triggers and does wonders for shooting tight groups.

Very easy to install.

Take care,Stan

I have the 3lb version of this trigger. It is a great trigger and easy to install.

Pugster
05-30-2009, 5:57 PM
+1 again on the 3lb Timney. I just installed one on my AR last night and it's a world apart from a standard trigger set.

God Bless The Mauser
05-30-2009, 7:13 PM
I installed a RRA national match 2 stage trigger and it is SO much better than the stock trigger, and it wasn't too expensive.

Artery
05-30-2009, 7:15 PM
That sounds like how mine was before I bought a new trigger

TurboAR
05-30-2009, 7:34 PM
Bill Springfields $50 3lb trigger job is amazing. Just send in your 2 stage RRA trigger, get it back in two days. Does help with tighter groupings big time.

wooger
05-30-2009, 7:36 PM
I'm using Geissele.

Flying Bones
07-22-2009, 3:43 PM
polish with felt wheel on a dremel, do not buff thru case hardening just buff lightly, use JP Springs @ $8.00 from Brownells and reassemble with grease on sear and hammer contacts

Any more info on how to do this work? Is there a tutorial on here that i'm missing?