View Full Version : **SOLD** Armalite 16" barrel

01-10-2009, 4:29 AM
** SOLD** Armalite M15A4 Carbine barrel assembly, 16", .223 barrel, 1/9 twist, Mid-Length gas system, picatinny gas block with sling swivel, front handguard cap, barrel nut. Comes with gas tube and pin. Does not come with delta ring, spring or retainer. Barrel measures a straight 0.875" diameter from chamber to gas block, 0.725" from gas block to muzzle.

Similar to the current Armalite B15A4C barrel, except the gas block on this barrel is pinned in place rather than clamped on as with the current twin screw variety. Barrel was removed from a 'new' unfired '99 Armalite M15A4C upper - Never fired beyond what was done at the factory during assembly.

Note: This had the factory muzzle brake permanently attached per the Federal regs at the time, however following the 2004 expiration, the brake was ground down to reveal both ends of the retaining pin, which was then drifted out to allow the brake to be unscrewed. The muzzle is threaded 1/2"x28 allowing for any standard AR muzzle attachment. The groove for the original retaining pin remains, however this does not impede the installation of new brakes/flash hiders. A new GI A2 flash hider and new crush washer are included. The A2 flash hider is screwed on hand tight to protect the threads only, and the buyer will be responsible for fitting an appropriate brake/flash hider depending on the legalities of their intended build/usage.

Parkerized finish, some minor storage marks, but otherwise as new as it came from the factory in '99.

** SOLD** $125 includes insured shipping. Payment to be made by USPS money order or VERY discreet Paypal (add 3% for Paypal). CA shipping ONLY at this time from OC. Thanks for looking!





Blacktail 8541
01-10-2009, 7:39 AM
I'll take the barrel. Pm comming

01-10-2009, 7:42 AM
i guess the earlier bird gets the worm.... missed by minutes


01-10-2009, 7:44 AM
PM sent

01-10-2009, 3:06 PM
PM Sent