PDA

View Full Version : SOLD: Custom Made AR15 "Non-Pistol Grip" Grip w/ Punisher Logo


SunriseF150
11-12-2008, 10:20 AM
Ok well I haven't really used this since I made it. And I've decided to make one that goes on a Magpul MIAD instead. So i'm putting this up for sale. I have a LOT of time into this thing. It's build good. I had to get it so both sides were equal, level, same thickness, curves, contours, ect. That was not easy. The plastic fin part is made with Duramix 4040, rigid plastic epoxy ($30 a tube). I made it to fit flush on an A2 stock. It's not going to look right on any other stock. It's not some cheap thing that is going to break right off. And yeah i'm sure if you tried to break the fin off you could. I easily have about 10-15 hours into building this. Mainly cause getting all the fitment, flush finish, equal sides, ect. all perfect. The Punisher logo is in white gloss, with a texture finish around it.

Keep the same angle as the standard pistol grip, without a pistol grip grasp, and as long as you have no other evil features you can use preban mags :D

$75 shipped. - SOLD to Long Beach

5150Marcelo
11-12-2008, 10:22 AM
That would actually look better if the skull wasnt filled in. All black is better.

SunriseF150
11-12-2008, 11:07 AM
I was actually thinking the white should have been a grey color. But all black would have been too much I think. With the size of the A2 stock and the grip I think it would have just looked too bulky.

Ballistic043
11-12-2008, 11:16 AM
wow, very professional looking. i can not wait to see what you do with a MIAD

5150Marcelo
11-12-2008, 11:17 AM
wow, very professional looking. i can not wait to see what you do with a MIAD

+1. Looks quality!

Pronghorn
11-12-2008, 11:39 AM
Looks alot better than the MMG. If I kept my AR's in CA, I'd be all over it.

Gregchico
11-12-2008, 12:58 PM
Free bump for a cool look...

The Bacon Eater
11-12-2008, 1:00 PM
I will take it. Pm sent