PDA

View Full Version : AR - Gas Tube Roll Pin - Whats the correct roll pin holder size?


mike22ca
09-14-2008, 3:20 PM
Id some work to my .50 beo upper and I was going to put the gas tube roll pin back in and found it was a real PITA. Was wondering if anyone knew the correct sized roll pin holder punch for that particular pin? That or any helpful hints of getting that little sucker back in without deforming it.

Mike

bohoki
09-14-2008, 3:37 PM
gee i just used a finishing nail

mike22ca
09-14-2008, 3:45 PM
gee i just used a finishing nail

Not a bad idea actually ;). Did u just punch the nail through and clip both ends off?

ar15barrels
09-14-2008, 7:15 PM
5/64 x 5/16

mike22ca
09-14-2008, 10:29 PM
5/64 x 5/16

Thank you sir.