PDA

View Full Version : prince 50 allen wrench size ?


H2H
07-02-2008, 9:46 AM
mine didn't come with one. I need to go buy one. I know it's smaller than the 0.50 allen wrench.

thanks

bonjing
07-02-2008, 9:50 AM
answer can be found here

http://www.calguns.net/calgunforum/showthread.php?t=96630

H2H
07-02-2008, 10:04 AM
thanks. I sent a PM to Prince50

bonjing
07-02-2008, 10:16 AM
no problem

Prince50
07-02-2008, 10:27 PM
If your allen wrench is smaller than .050. Your mag lock is not a real Prince50.

If your mag lock is just a standard button with a hole drilled and tapped it is not a real Prince50.

Unless your button is made from scratch, with horizontal grooves, and not circles. Unless the hole for the 4-40 set screw is anodized inside just like the bigger hole, it is not one of mine.

My buttons have always used 4-40 screws with .050 allen keys, and have been made from scratch since almost the very beginning.

I of course cannot supply allen keys for buttons I did not manufacture.

Thanks for the inquiry.

Darin

H2H
07-02-2008, 10:46 PM
let me check again I got the correct allen wrench

H2H
07-02-2008, 11:02 PM
looks like it's 0.050 but it's not working for me. Then again I'm using a cheap chinese allen set from Harbor Freight so it might be out of spec..

my kit looks like the one J&J sells:

http://www.jandjarmory.com/jjarmory/index.php?act=viewProd&productId=48